Hey Preston, Sorry I've never seen this part of the Rational site before, didn't even know it existed Aligning subs by phase response can be difficult if you can't get "clean" measurements. I'd advise practising phase alignment at higher freqs first, grab a two way box and a processor you can mangle syart around 1kHz with something easy Like LR24 slopes. Just looking at the outputs of the crossover can be interesting to start with then add a speaker to the mix and practice. Once you start heading south of @250Hz the wavelengths start getting much longer and sound is no longer behaving "ray-like" but more truly "wave-like" Learning what the Phase response is telling you is the most important thing. "When did which energy arrive when?" Where the Phase slope is horizontal is where Smaart's delay time is aligned to, you can manipulate this. I like to think of it as the "phase focus control" then I can see the relative time differences between different freq's. It's a lot easier to show than explain, get to one of Jamie's or Harry's classes once you see it it all falls into place. Cheers, ferrit
Found it. Little bugger was hiding from me. It was a Calvert post. Any wisdom you could impart on getting the most accurate phase reponse time alignment in sub and low frequency would be most helpful. I'm always looking to improve my techniques and learn from the experience of others Preston
Hi Ferrit I'm afriend of Paul Tucci's and a phase response convert since our lengthy conversations years ago. I'm looking for the thread that has the info on slowing down the timer for v6 I cant seem to run across it again. I remember how to do it on windows but plan on using the mac version now. Preston
